Phantom Channels or "hidden" channels

Message Topic Search Topic Options Post Reply Create New Topic Printable Version

   There are posts in other forums that mention the same. When importing channels from Spectrum, make sure that all of your channels are uniquely named prior to doing the import.

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version
jberner Members Profile Send Private Message Find Members Posts Add to Buddy List Groupie Joined: 12 Sep 2008 Location: Ruther Glen, VA Online Status: Offline Posts: 85	Quote Reply Topic: Phantom Channels or "hidden" channels Posted: 27 Sep 2008 at 1:55pm
	There are posts in other forums that mention the same. When importing channels from Spectrum, make sure that all of your channels are uniquely named prior to doing the import.

Jonathan Members Profile Send Private Message Find Members Posts Visit Members Homepage Add to Buddy List Beta Testers Joined: 07 Sep 2008 Location: SoCal Online Status: Offline Posts: 1237	Quote Reply Posted: 25 Sep 2008 at 6:41pm
	That recently happened to me as well when I imported a sequence from Spectrum. The only thing I had done differently on that import vs other imports was that I hadn't named my channels yet, they were just Track 1, Track 2, etc. All three controllers were the same way, and for whatever reason, only the first 16 channels showed up. However, once I imported channels from my template file I made just for Aurora, everything popped up just as it should be. The only thing I can think of was that each one of my three controllers had the exact same name for the 16 channels. Fortunately, my sequence was intact, and it did not need to be reloaded.
	~Jonathan

kalifi Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 10 Sep 2008 Online Status: Offline Posts: 25	Quote Reply Posted: 24 Sep 2008 at 9:03pm
	No, I didn't. I did mess with it a little. Because the commands were still showing up I took a gander. I "added" channels that matched the "phantom" ones labeling them appropriately and viola, the channel picked up the commands and showed them exactly as they were playing. The commands showed up in the proper channel and no need to redo stuff. So the info was in the sequence but just not showing in the "editor". Once I added the channels that the import didn't add it was exactly as it should have been. Thank goodness it was only 4 channels that went phantom. No extra sequencing needed and nothing lost. Thanks for responding. Edited by kalifi - 24 Sep 2008 at 9:05pm

ChrisL1976 Members Profile Send Private Message Find Members Posts Visit Members Homepage Add to Buddy List Beta Testers Joined: 01 Sep 2008 Location: Kankakee, Ill Online Status: Offline Posts: 1341	Quote Reply Posted: 24 Sep 2008 at 8:14pm
	Did you import spectrum sequences that contained Virtual Controllers?
	Chris www.lightsonsixth.com

kalifi Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 10 Sep 2008 Online Status: Offline Posts: 25	Quote Reply Posted: 24 Sep 2008 at 7:05pm
	I imported a sequence from Spectrum over to Aurora. I have some channels that cannot be seen on the left with all the channel listings but during playback to lights...the programmed commands show up. I cannot get the channels to show up so that I can edit the channels. I did not realize this either until quite a bit into the sequencing that I was doing so I fear all of the sequencing I did will be for not because I will have to scrap the sequence because of the phantom channels. Suggestions? Is this a bug?