Create new sequence crash

 

If I import channels (and it shouldn't as how I want to import), it looks as though Aurora thinks about getting the channel data, then nothing. I'm still at the Create/Cancel/New Sequence screen.

 

If I do not import channels, Everything loads, but I get nothing in the waveform area, no grid, and I cannot do anything. I'd basically a null project.

I've bee sequencing for another hour, then talked with my wife, with Aurora minimized for half an hour, then cheked email, then went back. I added a ramp, realised it was backwards, so I did SHIFT+R and could not close that popup.

I just can't put my finger on it though.

 

I'm on a Gateway Laptop, 1.7Ghz, 1G Ram, 27.7G free HDD, XP w/ SP3, ATI Mobility Raedon X600 SE.

 

I was sequencing, with an audio section highlit.

Audio was not playing, not paused.

Ben mixing trying to replicate it while doing my first sequence.

 

 

Yep, MP3s here. Still somewhat in the "playing" mode. But if it works, it's just esier to copy over the MP3s from the main music directory to the audio dir.

 

Now, I had rebooted, opened Aurora, saw that it worked fine, the closed it out. I shut the lid on the laptop...

Hour or so later, I'm going back in to sequence more and I'm stuck at "Decompiling" again.

 

reboot time.