How to get a closing sequence to play at the end

Well it worked. It stopped playing the currant show and started the closing sequence.

I would like to wish everyone here, in the BETA testing thread, a very Merry Christmas.

It should exit the loop at 11pm and run the next show (your closing "show") after that without any problem, but I don't believe we have tested that specific use case.  Most testing has assumed use of the "until end of schedule" option rather than a time override at the show level.

Michael

For a closing sequence, your schedule should look something like this:



The above example (edited with red text and a yellow oval for clarity) will start by running the sequences in the "Preshow Warmup" show only once, then will loop through the sequences in "2014 Main Loop" show until the end of the schedule time, and then will run the sequences specified in the "Closing Sequence" show only once.

In 307 one or more sequences are assigned to a "show", and multiple shows are assigned to a "schedule" item.  This allows for a lot of flexibility when it comes to scheduling.  It is even possible to run different shows at different times of the night (not shown in the above example).  The only "gotcha" is that rolling over past midnight is poorly supported at this time.

Edit: To answer your question, there will be no gap between the last looped sequence of the main show and the first sequence of the closing show (which for most people will contain only one sequence).

Michael


Edited by LightsOnLogan - 22 Dec 2014 at 2:29pm

Closing sequences are still possible.  Heck, I'm using three of them this year (same "show hours" song- one sequence with all lights, one with just the security lights, and then no lights repeating).  Just tell the main loop (in the "Schedule Shows") to end a few minutes before the end of the show (found in the "Schedule Dates" box) and then set up a new show and tell it to run once.