importing Channel lineup

Pete and venesa     did you by chance figure anything out after that sequence crashed?

Something is goofy with the file.   I just imported a old 16 ch.  d-light sequence I have here at home, saved it as test 1

Opened a new sequence and imported test 1 lineup and it goes in clean. No errors in the Draw menu

My issue is that the template file I linked above, I created from scratch on aurora and its still goofy.

Only thing I can think of is the picture file is somehow affecting things.....I'll resize it to 600x800 because you said that works.

I'll try to reload my 64 ch D-light lineup on my work computer and see if I can open, save  and relink it to another new Aurora file.


I'm afraid I'm going to use my work around (of saving the file under another name, inserting the new music and then sequencing)  and I'm going to get to showtime and the file going to be goofy and not work.

Right now I'm I have like 2 minutes of very basic voice over sequence done so I can redo those easily.  


Edited by ChrisL1976 - 04 Sep 2008 at 6:19pm

I don't think it's the picture file at all since I have a different picture file and it's still goofy.

Post it up here when you created it and I'll see if I can get the same errors

Let me make a $1 bet that this will come back and bite us. In the template I download it didn't have the pic that you have, therefore it loads the default picture which comes with Aurora.

There, there, I told ya, there's somthin lurking in them there code

Edited by peteandvanessa - 05 Sep 2008 at 2:53pm