Sequence not playing

I am unable to play a sequence.  Light is solid on d-light board but no show.  Tried different comms and settings on PC and software but still nothing.  Even deleted and reinstalled software, comm ports and drivers.  Utility turns light on and off and I do disconnect before exiting.  File runs fine on laptop.  Anyone had this problem before.  I am using latest versions of everythingiI can think of._popupControl();

_popupControl(); Yes discovered numerous times.  It did work once this morning after automatic windows update reset PC last night and I ran utility and use the get button under protcol to retrive com settings.  It has occasionally trigger a few channels before but this morning it looked like it was running but after I reset PC nothing again.  Some sort of com problem but everything looks ok.

I am trying to use scheduler version 1 build 69 using FTDI version 2.6 serial converter on com port 3 FTDI version 2.6.  I was using scheduler 32 using the older drivers but it also did not work.  I have deleted the entire usb and com ports and rebooted and still nothing.  I will try to delete everything again and look at regedit for clues.  _popupControl();

_popupControl(); Scheduler,  I have clicked the icon.  I uninstalled, completed removed the software in program files, regedit the words Aurora and dls, removed phantom USB and coms in device manager and rebooted between all and reloaded software, same thing, utility works to turn lights on but the schedular does not.  I am hoping new version might fix problem but I have done all I know to do.

Just to verify since no one has asked yet, you did set up your networks in Aurora, right?  If you didn't, clicking the light bulb will do nothing as it has no network to send commands out to.  If you didn't, you can do this in Settings, Serial Networks.  If the network speed 115200 doesn't seem to work for you (for example if you use wiLink), then try 57600.  Don't forget, you can change the settings in either Borealis Scheduler or Aurora Sequencer and it will carry over to the other program.

Also, when updating the drivers, there are two parts that need to be updated.  Most of my issues went away once I realized this.  Here are the instructions from LightsOnLogan on how to do that: