lights to controller

Check your com port setting in aurora, and click the light bulb to send output to the controller...

com port is set    when i click light bulb  nothing happens        john

I made this mistake,  does the controller ID# match the ID# that is assigned to the controller in Aurora. Check under bulk editor

If the unit ID is set at 2 then when you check the bulk editor the ID should match

Hope this helps

If you have the HW utility open can you turn the lights on ??


Edited by mramsey - 12 Nov 2008 at 8:11am

Forgive the basic descriptions if you already know this information.

Use your hardware utility program  to determine which device number your controller is on.  This is done through the Discover tab on D-lights hardware utility (I'm sure LOR has something similar if your using LOR controllers)  Open HWU, Connect to the controller, the flashing red lights will go solid, and open the discover tab and click Discover.  It will come up with a number on the left side. The default is 2 if you have never changed it. 

Once you know that number, you have to change the device number on your channels in aurora to match that number.  

The device number for your channels must match the device number set in the controller.  This is how you can use multiple controllers. You change the controller Device number to match your Aurora device number.   I have 4 controllers  numbered 1-4. That way each group of 16 channels has a different address.   The device number is the address. 

controller type is configured in settings    light does go solid    i believe i dont have each channel matched with controller   ill try that  and see what happens   thanks for help   john