Another RGB related issue

 I'm not sure where to go with this one.  I have 1 DCx16 in my setup and It's set as ID #9.  Channels 1, 2 and 3 are setup as RGB for my MR16 color wash floods. Channel 4 is set as plain old white for some MR16s I use on some coro cut-outs.  In the HW utility I can run any test I want there and all four channels work.  When I run scheduler or sequencer the white spots (channel 4) dont ever come on.  When I right click on channel 4 and look at the properties I see Network 1 (I only have the one network) ID 9 and channel 4.  When I look at the properties for the RGB floods I see Network 1 ID 9 and channels 1, 2 and 3, just how I would imagine it SHOULD look...  Any ideas why channels 1, 2 and 3 work but 4 dosen't? And only in the sequencer and scheduler?

As a test I made another RGB (set of) channel(s) with 4, 5 and 6, 4 being my problem channel.  When I put a command on that RGB set the white lights come on. Tried going back to JUST a single channel on DCx16 and it still doesn't work.

We'll look into this, but be patient if the response time is a little slow.  Trust me, things are going at a rapid pace behind the scenes right now.  

What firmware is your DCx16 using?

v2.0 added a lot of fixes, including "enhanced effects".  I've had effects prgrammed since last year that are finally getting used.  (Random Shimmer ramp out looks great, BTW with a strobe light).  Try v2.0 and see if that helps, but also make sure you are using the newest Firmware Updater (v2.2.2 as of this writing).  While you're at it, download the newest HW Utility, v2.4.2 if you haven't already.