Aurora Homepage
Forum Home Forum Home > Aurora Sequencer Software > Aurora 1.0 > Installation Issues
  Active Topics Active Topics
  FAQ FAQ  Forum Search   Calendar   Register Register  Login Login

Second controler box not working

 Post Reply Post Reply
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
garagemahall4 View Drop Down
Newbie
Newbie


Joined: 12 Nov 2008
Online Status: Offline
Posts: 14
  Quote garagemahall4 Quote  Post ReplyReply Direct Link To This Post Topic: Second controler box not working
    Posted: 03 Dec 2011 at 5:19pm
Hello and please help, I have the D-light hardware and D-light ACx16 and my system works fine, now I have added another device, LOR CTB16 and have created a lighting sequence and the lighting comanned is not going to the new box, when I go to the D-light hardware utility and pick comport 1, nothing happens on 16 cannel test, when I pick comport 4, [those are my only choises], on 16 channel test all 32 work.  Now the first box is, device type for channel 1-16 is D-light ACx16, network segment 2, device ID 2,  the second box is, device type for channel 17-32 is LOR CTB16, network segment 1, device ID 1. When I got the LOR CTB16, it said it was set to #1. I must be missing a step, maybe IDing the new box to my hardware utility, please help, and step by step would be very heplful, many thanks in advance.
Back to Top
Jonathan View Drop Down
Beta Testers
Beta Testers


Joined: 07 Sep 2008
Location: SoCal
Online Status: Offline
Posts: 1237
  Quote Jonathan Quote  Post ReplyReply Direct Link To This Post Posted: 03 Dec 2011 at 10:28pm
As far as Aurora goes, both controllers should be run off of one RS485 dongle via Net 1.  With two controllers, you do not (nor should you) run off of Net 2.  For now, keep the ID's the same (LOR as ID 1 and D-Light as ID 2).  When you turn on the D-Light HW Utility, it is telling you that your RS485 dongle is assigned to COM 4.  Make sure that is correctly reflected in Aurora's Playback Settings:  Net 1; COM 4.  Make sure your sequences are programmed to this configuration as well.

If all your lights are turning on in the HW Utility when ID 1 is selected, it either means that both boxes are assigned to ID 1, you have the "All" box checked, or you are hitting "All On" instead of just "On".  Use the HW Utility's Discover tab to find your D-Light controller.  Then make sure it is set to the ID you have programmed your sequences with.  If not, change it in the general setting tab.
~Jonathan
Back to Top
garagemahall4 View Drop Down
Newbie
Newbie


Joined: 12 Nov 2008
Online Status: Offline
Posts: 14
  Quote garagemahall4 Quote  Post ReplyReply Direct Link To This Post Posted: 03 Dec 2011 at 10:44pm
WinkTongue Thanks so much, I change the network segment to the same for both boxes and now it all works, thanks so much again and have a great holiday with lights.  John
Back to Top
 Post Reply Post Reply

Forum Jump Forum Permissions View Drop Down

Bulletin Board Software by Web Wiz Forums® version 9.06
Copyright ©2001-2007 Web Wiz

This page was generated in 0.781 seconds.