Aurora Homepage
Main Hardware Software Cables/Adapters Forum Contact
Forum Home Forum Home > Aurora Sequencer Software > Questions About Aurora
  Active Topics Active Topics
  FAQ FAQ  Forum Search   Calendar   Register Register  Login Login

Ready to put up lights but have one question!
 Post Reply Post Reply Page  <12
Author
Message
  Topic Search Topic Search  Topic Options Topic Options
Pony_God View Drop Down
Senior Member
Senior Member
Avatar

Joined: 01 Sep 2008
Location: Naples, FL
Online Status: Offline
Posts: 551 		  Quote Pony_God Quote  Post ReplyReply Direct Link To This Post Posted: 13 Nov 2008 at 11:36am
Does it really matter how far? What's entailed in termination? resister between wire X and Y?
Fine. You're so smart you rig up the lights.
D-Light users Unite!
Back to Top
JonB256 View Drop Down
DMX
DMX
Avatar

Joined: 19 Dec 2007
Location: Granbury, TX
Online Status: Offline
Posts: 130 		  Quote JonB256 Quote  Post ReplyReply Direct Link To This Post Posted: 13 Nov 2008 at 9:38pm

Looked around and found one source that said the far end should be terminated with a 120 ohm resistor. It also said the total daisy chain could be 1.2kilometers long.

I'll ignore both items. Wink
JonB - D-Light user
Back to Top
Pony_God View Drop Down
Senior Member
Senior Member
Avatar

Joined: 01 Sep 2008
Location: Naples, FL
Online Status: Offline
Posts: 551 		  Quote Pony_God Quote  Post ReplyReply Direct Link To This Post Posted: 14 Nov 2008 at 8:00am
I'd be happy to build a little terminator that just plugs in if it fixes a single error, and it it follows the RS485 spec better.
Fine. You're so smart you rig up the lights.
D-Light users Unite!
Back to Top
 Post Reply Post Reply Page  <12

Forum Jump Forum Permissions View Drop Down

Bulletin Board Software by Web Wiz Forums® version 9.06
Copyright ©2001-2007 Web Wiz

This page was generated in 0.906 seconds.