Expand the RGB tool further

Originally posted by Pony_God So you're looking to have the red channel, blue channel, and green channel, AND an extra channel that's a combo of the last three? Isn't that just more junk on the screen? Why would you need the red channel, if you could just select red from the rgb channel?

Yes, its more stuff on the screen, but not necessary to be seen during sequencing.  You can push it to the bottom, off screen.  You can just pull it up if needed.  

Originally posted by Pony_God Not to argue or anything

Thems fighting words....

Just to over complicate the heck out of the program.    My only thought would be to provide better clarity for multi-channel commands.  If your lighting up more than one of the RGB channels at the same time may show up better on multi-lines than the one single line.  It was just a thought, most likely "like I said" over complicate the programing.

It may make setup easier for new users.  Unless I'm not doing it right and keep getting error mssages becaseu of that. If I want to setup a flood mix with the RGB tool now. If I create a 16 channel controller, I have to go erase the 3 RGB channels I want to use before it will let me set up the one RGB channel. 

More or less if you try to create a D-light RBG (over ACx16) channel, if the 3 channels you plan on using are already listed, it wont let you. You have to delete the channels first.