Lights firing at the wrong time.

Message Topic Search Topic Options Post Reply Create New Topic Printable Version

I have an almost complete sequence but when I test it through Aurora it has 2 channels firing at the same time when I have clearly made sure they should not be firing at the same time.  I first thought this was an issue with ramps so I turned all the ramps to on an still getting the same problem.  It only happens during one small part of the sequence.  When viewing in visualizer it seems fine but when I send to lights is when the issue begins.  It only seems to be 2 channels doing this as well.  Rest of the sequence seems to run fine.  At first I thought I had a couple of channels plugged in to the wrong output cords but when I check in hardware utility everything seems fine.  

Edited by HarleyHaynes - 21 Dec 2008 at 9:42pm

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version
HarleyHaynes Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 21 Dec 2008 Location: Kingwood, Texas Online Status: Offline Posts: 10	Quote Reply Topic: Lights firing at the wrong time. Posted: 21 Dec 2008 at 9:41pm
	I have an almost complete sequence but when I test it through Aurora it has 2 channels firing at the same time when I have clearly made sure they should not be firing at the same time. I first thought this was an issue with ramps so I turned all the ramps to on an still getting the same problem. It only happens during one small part of the sequence. When viewing in visualizer it seems fine but when I send to lights is when the issue begins. It only seems to be 2 channels doing this as well. Rest of the sequence seems to run fine. At first I thought I had a couple of channels plugged in to the wrong output cords but when I check in hardware utility everything seems fine. Edited by HarleyHaynes - 21 Dec 2008 at 9:42pm

Jonathan Members Profile Send Private Message Find Members Posts Visit Members Homepage Add to Buddy List Beta Testers Joined: 07 Sep 2008 Location: SoCal Online Status: Offline Posts: 1237	Quote Reply Posted: 21 Dec 2008 at 10:44pm
	What kind of strands are misfiring? Are they LED's? What version of Aurora are you using? (1.0.41?) Does this also occur in Borealis Scheduler, or just the sequencer?
	~Jonathan

HarleyHaynes Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: 21 Dec 2008 Location: Kingwood, Texas Online Status: Offline Posts: 10	Quote Reply Posted: 30 Dec 2008 at 10:31pm
	I got the issue worked out. Newbie I D 10 t error