LOR Board LAGGING

I just reread the thread and realized that it is a single controller board that is glitching (but all of the others are working properly).  Is this correct?

I had mistakenly assumed that it was your whole network that was glitching which resembles an issue we've seen with the VCP drivers before.  However, if it is just one board that is glitching then you need to look for problems at that specific board.  Aurora doesn't care if the board can be detected or not... it will always output data for all of the boards.  If the rest of your boards are reacting at the proper time then the data has already gone down the wire and is being held at that board for some reason.

Michael

I have given up on xlights for now. I believe it is an audio codec issue or something wierd, but it will not run an entire show without crashing. I do have some good news Michael! My sequence that consistantly lags is no longer lagging! I can not say for sure, but is seems to be related to some extra channels that are in my sequences. Last year I made some changes to my setup and channels. When I imported channels from file, it pushed the unused channels to the bottom. When added the new channels, they would duplicate the n/d/c settings of the old channels. I did not want to delete the old channels because they contained events that I wanted to be able to copy and use. So to correct for the duplication, I simply changed the old channels to Network 2. Now I do not use multiple networks and do not have a second network setup in the network settings.